MoparFins

Please login or register.

Login with username, password and session length
Advanced search  

News:

We changed servers, which is good, and lost all passwords, which is bad. See above.

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Keith

Pages: [1]
1
Tech- - DRIVE TRAIN / cross reference
« on: May 03, 2009, 02:25:26 AM »
Ok so I'm gonna assume its an 833 or an OD A833, what is either one worth? Maybe this will help, the case is Aluminum, but the side plate & tailshaft is cast Iron or steel. A ll I need to know is if I put it on the market, what is the COMPLETE setup worth ? I dont want to give it away,  yet I dont want to rob anyone either.

2
Tech- - DRIVE TRAIN / cross reference
« on: May 02, 2009, 02:03:21 PM »
I assuming the OD refers to Overdrive, right ? If so, that still doesnt tell me the value of the setup that I have. Would you care to elaborat on the price of a complete setup ? I do need the $ but I also have my eyes on a 74 Duster, and as bad as the 4 might make it, I dont wanna go thru all the BS to convert from auto to std. I did that once to a 66' Cornet with a 383 4bbl Police Interceptor. That was back in the 70's and it was a pain it the ass to convert from auto to std.
  I have COPD which is a lung disease & might be lung cancer to boot, so it really dont matter one way or another if I sell it or not. I'd just like an honest answer of what the total pkg would be worth. I have 3 kids, a grandson, a wife, and 2 stepsons. Whatever I get out of the setup, goes to my Grandson cause I want him to try and go to College. Hes not even 10 months old yet, but he's my 1st grandbaby so all goes to him

3
Tech- - DRIVE TRAIN / cross reference
« on: May 02, 2009, 03:53:09 AM »
To be honest I cant remember the the exact year the motor was. What I do remember is seeing the 360 stamp on the block and it had a 4bbl Q-Jet carb on it. I sold the engine for $100.00 as is and it turned out to have a cracked block. The motor & tranny came out of a 80' model dodge p/u that I had bought sight unseen. I do know however that it is a car 4-spd. I've no doubt you know your Mopars so now my ? would be whats the setup worth?
  I ck'd a Mopar used parts list price guide and this was the results
 23 Spline 70-74 B&E Body $425.00
 Flywheel $120.00 ( bal 360 $155.00 )
 Throwout Fork A-Body $35.00...B&E Body $55.00
 This doesnt count Bellhousing, Clutch & Pressure Plate, Shifter, Z-Bar, ect.

4
Tech- - DRIVE TRAIN / cross reference
« on: May 01, 2009, 07:07:14 PM »
Does anyone have a cross reference for serial numbers on a Mopar 4-sd ? I've got all the numbers off of it, but the morons I've talked to cant give me an answer as to what type 4-spd I have or even what it may be worth. It's complete, Clutch, Pressure Plate, Bell Housing, Throwout Bearing, & shifter. It came off a 67' 360 which I know is a Sm block. Can anyone help me ? I'd appericate it if anyone can.

Pages: [1]
© 2008-2014 Steve Hobby • © 2015 Allpar, LLC