MoparFins

Please login or register.

Login with username, password and session length
Advanced search  

News:

We changed servers, which is good, and lost all passwords, which is bad. See above.

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - GoWyo!

Pages: [1]
1
Tech- - ELECTRICAL / Passenger windows on '68 Sport Fury
« on: June 20, 2009, 07:20:00 AM »
Howdy all,
 
One of the priorities or last to do items on my list is to fix the electric quarter windows on my fastback.  Both are dead.
 
I'm assuming the motors are seized from inactivity, but... 
 
I've seen references to motor interchangeability over the past couple of years, but never printed them off of the other sites.  Does anyone have any info?  I seem to remember that the motors from an '85 lebaron were compatible.
 
Also there were threads about the exchange process that might save one's fingers.
 
Does anyone have those in a file? Any other hints to try?
 
Thanks,
 
Gary

2
General Tech / Torque Thrust II's on a Sport Fury
« on: June 16, 2009, 07:28:45 PM »
Howdy,
 
I know, two posts in one night...in a year!  I've been looking for new tires and have given up on the 8x14's.  I've looked and looked for the past two years and I've decided on the AR TT II's.  15x8's would be a little bigger than OEM steel, but I'm asking if anyone has put these on their C or even a Sport Fury?
 
Million dollar question, will they fit over the drums?  If not, how big would I need to go.  I don't want wagon wheels.  Also not certain how they'd look with the drum vs. discs.  May look to swap out in the future.  I need rubber on the ground!  The Bias ply's on it are OEM and weather checked and cracked like you wouldn't believe (ok 41 years old...you'd believe and the valve stems are rotting on two.
 
Thanks,
 
Gary

3
Howdy all,
 
Ok, so I bought some KYB's for the 68 SF.  I've got the rears on no sweat, I took off the Lt front and after debating , I cut the retaining strap and put on the inner/ lower washer and bushing.  The OEM set up had a inner bushing sleeve in the  one piece bushing-bumper, I don't see a replacement nor is it indicated in the pictograph instructions.  (hate those btw) is that sleeve necessary?  it doesn't appear to fit.
 
Is there a trick to keeping the new shock compressed while one inserts/ threads it into place?  Thing is tougher than I am.  After 6 attempts of compressing the shaft against the frame and not being quick enough to position it(the entire time being eaten by mosquitos) I said enough for the night.  I'll try again tomorrow.

Pages: [1]
© 2008-2014 Steve Hobby • © 2015 Allpar, LLC