MoparFins

Please login or register.

Login with username, password and session length
Advanced search  

News:

We changed servers, which is good, and lost all passwords, which is bad. See above.

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - mhutch1948

Pages: [1]
1
Tech- - DRIVE TRAIN / Re: Cable shift on column 65 Dodge Coronet
« on: October 27, 2016, 03:48:56 PM »
I had the same problem after  (A) mechanic changed the trans in my 65 dodge Monaco.  I finally figured it out.  Where I lived at the time you couldn't do much work on your cars without the management throwing a fit.

2
Tech- - Engine / Re: 55 dodge coronet motor mounts
« on: September 19, 2016, 06:00:52 PM »
forgot to ask in my post  does any one know where to find steel engine mounts for a 318 70s car or pick up truck?  I can find the rubber parts but not the steel mount, block to rubber part

3
Tech- - Engine / 55 dodge coronet motor mounts
« on: September 19, 2016, 05:51:37 PM »
hello every one;  I have a 55 dodge coronet 2dr sedan, and I plan on putting the 318 motor, trans, and rear end from my 88 Chrysler in it.  my question is  has any one here done a swap like this?  i can build what I need ,but it would help if I knew what I would need in advance  car has short block (striped motor 270 poly) bell housing clutch assm 3spd trans drive shaft rear end.  motor is junk.  so thanks all,  mike

Pages: [1]
© 2008-2014 Steve Hobby • © 2015 Allpar, LLC