MoparFins

Techical Discussions => Tech- - Engine => Topic started by: mhutch1948 on September 19, 2016, 05:51:37 PM

Title: 55 dodge coronet motor mounts
Post by: mhutch1948 on September 19, 2016, 05:51:37 PM
hello every one;  I have a 55 dodge coronet 2dr sedan, and I plan on putting the 318 motor, trans, and rear end from my 88 Chrysler in it.  my question is  has any one here done a swap like this?  i can build what I need ,but it would help if I knew what I would need in advance  car has short block (striped motor 270 poly) bell housing clutch assm 3spd trans drive shaft rear end.  motor is junk.  so thanks all,  mike
Title: Re: 55 dodge coronet motor mounts
Post by: mhutch1948 on September 19, 2016, 06:00:52 PM
forgot to ask in my post  does any one know where to find steel engine mounts for a 318 70s car or pick up truck?  I can find the rubber parts but not the steel mount, block to rubber part