MoparFins

Techical Discussions => Tech- - DRIVE TRAIN => Topic started by: Brian on February 05, 2013, 12:20:38 PM

Title: Transmission mount dimensions...
Post by: Brian on February 05, 2013, 12:20:38 PM
I'm looking for some kind of a source..on-line, or catalog, that list
transmission mounts and their...Height, length, bolt spacing, etc.  I've
 been scouring the internet for weeks now and can not find anything.  I
have found a few dimensions here and there...but nothing that gives me a
 wide enough range of mounts to try and find the one I need to make the
transmission cross member for the crewcab, work with the NV4500.

Closest
 I've got solving my problem was an E-mail I sent to Advanced adapters
asking if they carried a conversion mount, or cross member for this kind
 of a swap...Getrag 360 to a NV4500.  I received a response, and a small
 PDF file that showed some slight modification to the stock cross
member, and the running a GM TH350/400 tranny mount.  I tried this but
the mount it too short.

Anyone have a source?


Title: Transmission mount dimensions...
Post by: Steve on February 05, 2013, 12:58:04 PM


Word of advice. . . Don't take the lap top under the truck with you.   LOL
Title: Transmission mount dimensions...
Post by: Brian on February 05, 2013, 01:49:16 PM

Quote from: POLARACO


Thanks Steve...I'll check them out.  And thanks for the heads up on  bringing a laptop under the truck...(http://www.moparfins.com/forum/smileys/smiley2.gif)

Title: Transmission mount dimensions...
Post by: Steve on February 05, 2013, 04:15:02 PM


Not so bad with a 4 X 4, but a 2 X 4 with running boards is a real pain.
Title: Transmission mount dimensions...
Post by: Brian on February 05, 2013, 05:55:52 PM
My chest just barely clears the frame on my truck when I'm sliding under.


Title: Transmission mount dimensions...
Post by: Steve on February 05, 2013, 06:16:32 PM


I was thinking about replacing the front springs with a OE set of replacements which will give me an inch lift and get it realigned.  The front coils are pretty caved in.
Title: Transmission mount dimensions...
Post by: Brian on February 05, 2013, 07:11:41 PM
Yeah my front end sags pretty good too...the drivers side coil already has two of those "helpers"between a couple coils.(http://www.moparfins.com/forum/smileys/smiley36.gif)



Title: Transmission mount dimensions...
Post by: Steve on February 06, 2013, 06:44:09 AM


Wish I could put air bags in them.  I did see a kit that mounts the shock outside though.  My shock runs up the middle of the spring.
Title: Transmission mount dimensions...
Post by: Brian on February 06, 2013, 07:52:57 AM
Steve...I was looking at the Summit site last night and could not find any dimensions for tranny mounts.  Maybe I was not looking in the right spot?


Title: Transmission mount dimensions...
Post by: Steve on February 06, 2013, 11:48:52 AM


They have a details section in the product window.