MoparFins

Members Projects => MEMBERS Project Cars in Progress => Topic started by: Andy on April 03, 2009, 01:07:59 PM

Title: Project 64 300
Post by: Andy on April 03, 2009, 01:07:59 PM
Thought I'd post the latest picture of the 300 and a short description of the work done so far.
 
426 Hemi installed
New Custom Built Front Clip
Power Rack and Pinion Steering
Independent Front Suspension
Front Disc Brakes
Drive Train Systems rear end, 3:55 gear and disc brakes
 
I've begun wiring the car, using a Painless 18 Circut Universal Harness. Slow going with this, due to my lack of knowledge of ANYTHING to do with electricity! I can sucessfully turn switches on and off. Beyond that I'm in unexplored territory!(http://www.moparfins.com/forum/smileys/smiley8.gif)
 
Spent the last few days sanding and priming all the small brackets, braces and other small parts in preparation for installing the front end. Reconditioned some dash panels, panel the push button trans buttons fit into and the heater A/C controls, even though they won't be working. Next project may be putting in the interior insulation/sound deadener on the floor.
 
(http://www.moparfins.com/forum/attachments/215/Chrysler_front-a.jpg)
 
 
Title: Project 64 300
Post by: Steve on April 03, 2009, 01:25:54 PM
I found a place that is one heck of allot less expensive than painless
 
http://stores.homestead.com/ez2wire/StoreFront.bok (http://stores.homestead.com/ez2wire/StoreFront.bok)
 
Probably too late now. . . .